EMC Qlogic QLA22xx Instalační příručka stáhnout pdf (Strana 5)

Symmetrix Fibre Channel with Qlogic HBAs on Linux Hosts

Arbitrated Loop Configurations

Configuring

Firmware Settings

After the HBA is installed, follow these steps to verify and configure

HBA firmware settings.

Verifying the Correct

Firmware Version

The firmware (HBA BIOS) version can be determined at boot time

from the QLA2200F banner or from the Fast!Util Options menu.

◆ To determine the firmware version from the QLA2200F banner,

boot the host and watch for the banner:

Figure 1 QLA2200F Banner

• If the ROM BIOS is v1.61, continue to Setting the NVRAM

Variables on page 7.

• If the ROM BIOS is not v1.61, upgrade the firmware as

described under Upgrading the HBA BIOS on page 6; then go to

Setting the NVRAM Variables on page 7.

◆ To determine the firmware version from the QLA2200 Fast!Util

Options menu:

a. Boot the host. As soon as the QLA2200F banner (see Figure 1)

appears, press

ALT-Q to enter the Fast!Util Options menu.

b. Select Configuration Settings from the menu.

c. Select Host Adapter Settings from the Configuration Settings

menu.

d. Under Host Adapter Settings, note the BIOS Version:

•If the version is 1.61, continue to Setting the NVRAM

Variables.

•If the version is not 1.61, upgrade the firmware as described

under Upgrading the HBA BIOS on page 6; then proceed to

Setting the NVRAM Variables.

Qlogic Corporation

QLA2200 PCI Fibre Channel ROM BIOS Version 1.61

Press <ALT - Q> for Fast!UTIL

www.qlogic.com

1 2 3 4 5 6 7 8 9 10 ... 75 76

Žádné komentáře

EMC Qlogic QLA22xx Instalační příručka Strana 5