EMC Qlogic QLA22xx Instalační příručka stáhnout pdf (Strana 43)

Configuring a Symmetrix Boot Device

3-7

Configuring an EMC Boot Device

Installing the Windows OS onto the Boot Device

Follow the appropriate steps below to install the Windows operating

system onto the EMC boot device.

Windows 2000 For detailed installation instructions on the HP ProLiant BL20p G2

and BL40p, refer to HP ProLiant BL p-Class server blades Booting

Windows systems from 3

party Storage Array Network (SAN), How To,

located here:

ftp://ftp.compaq.com/pub/supportinformation/techpubs/

other/5982-3248en_rev1_us.pdf

After completing Windows installation, reinstall the QLogic driver

using the steps under Installation Procedure for Windows 2000 and

Windows 2003 Hosts on page 2-16.

Installing EFI boot code onto the HBA

To boot from a Symmetrix device via a QLogic fibre controller under

the Extensible Firmware Interface (EFI) shell, QLogic EFI boot code

must be loaded to the HBA. EFI boot code provides the ability to boot

from an attached device over Fibre Channel.

Check the EMC Support Matrix for the minimum required EFI boot

code revision.

The CD-ROM contains the latest EMC-approved EFI boot code at the

time of this document’s release. Update EFI boot code files, if

available, can be found on the qLogic website

http://www.qlogic.com

NOTE: If your system does not have a floppy disk driver, a USB pen drive

can be used to run utilities and store files for this procedure. Check with your

server vendor to determine whether a USB pen drive is supported for your

system.

If a system contains of mixture of detected and undetected adapters,

any existing

EFI drivers loaded by EFI should be unloaded using the EFI Shell

drivers, and unload commands. If you have not previously

installed EFI boot code to your QLogic HBA, skip this section.

QLogic_Windows.book Page 7 Friday, May 27, 2005 3:53 PM

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 105 106

Žádné komentáře

EMC Qlogic QLA22xx Instalační příručka Strana 43