EMC Qlogic QLA22xx Instalační příručka Strana 98
- Strana / 106
- Tabulka s obsahem
- ŘEŠENÍ PROBLÉMŮ
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
B
B-4
EMC Fibre Channel with QLogic HBAs in the Windows Environment
Third-Party Software
VERITAS Volume Management Software for Windows Operating
Systems
Refer to the latest EMC Support Matrix to determine which VERITAS Volume
Manager 3.x configurations are supported, and what service packs may be
required.
CAUTION
!
Configuring large numbers of device paths with VERITAS Volume
Manager can cause a Windows system to boot very slowly, and in
some cases overrun the NTLDR boot-time registry size and halt.
Systems that are configured with more than 512 device paths (total
paths to all LUNs) should check with EMC Customer Service
before installing VERITAS Volume Manager 3.x.
The C-bit is required on Symmetrix director ports connected to systems
running VERITAS DMP. Users of EMC ControlCenter 5.1 and greater should
consult their ControlCenter documentation for directions on making this
change. Other users must contact their EMC representative to make this
change.
VERITAS Volume Manager 3.0
If using PowerPath with VERITAS Volume Manager 3.0 with Service
Pack 1, you must also make the following registry modifications
before PowerPath devices will be available to the VERITAS
Enterprise Manager:
Use regedt32.exe to set the registry as follows:
HKEY_LOCAL_MACHINE\SOFTWARE\VERITAS\VxSvc\CurrentVersion\VolumeManager
value name = ShowGateKeeperDevices
data type = REG_DWORD
value = 0x1
HKEY_LOCAL_MACHINE\SOFTWARE\VERITAS\VxSvc\CurrentVersion\VolumeManager
value name = ShowEmcHiddenDevices
data type = REG_DWORD
value = 0x1
After completing these changes, reboot the host system.
QLogic_Windows.book Page 4 Friday, May 27, 2005 3:53 PM
- EMC Fibre Channel with 1
- Windows Environment 1
- Contents 3
- HBA (TOE) 5
- Appendix C Troubleshooting 6
- AVANT GARDE 8
- Introduction 10
- Installing and 13
- Configuring the HBA 13
- Installing an HBA 15
- Clustering Configurations 16
- EMC HBA Settings 20
- Configuring NVRAM 21
- Manually Setting the 24
- HBA Data Rate 24
- Installing the HBA Driver 26
- Where to Find the 27
- Windows 2003 STORPort Updates 27
- 18. Reboot the host 29
- Replacing an HBA 33
- Configuring an EMC 37
- Boot Device 37
- Boot-from-SAN with MSCS 40
- Configuring the Boot BIOS 41
- , type fs1: and 44
- <handle> 46
- <control> 46
- Procedure Flowchart 49
- Requirements 51
- Preparing the Storage System 52
- Setting Up the HBA BIOS 53
- Preparing the Fabric 54
- QLogic Corporation 55
- Preparing the Server 57
- Boot BIOS 58
- Installing Windows 60
- Starting a Fresh Installation 69
- Replacing a Boot HBA 71
- Known Issues 73
- Configuring the 75
- QLogic QLA4010 iSCSI 75
- Setting Up External Boot 93
- HS40 (8839) 93
- External Array 94
- Manager Software or Agents 96
- SANSurfer Version 97
- VERITAS Volume Manager 3.0 98
- VERITAS Foundation Suite 4.1 99
- VERITAS Foundation Suite 4.2 99
- Third-Party Software 100
- Troubleshooting 101
- Problems and Solutions 102
- Problem 4 103
- Problem 5 103
- Problem 6 103
- Problem 7 104
- Problem 8 104
Související produkty a manuály pro Sítě EMC Qlogic QLA22xx
Sítě EMC Qlogic QLA23xx Instalační příručka
(128 stránky)
(128 stránky)
Sítě EMC Qlogic QLA22xx Instalační příručka
(78 stránky)
(78 stránky)
Sítě EMC QLogic Instalační příručka
(216 stránky)
(216 stránky)
Sítě EMC QLogic Instalační příručka
(150 stránky)
(150 stránky)
Electrolux EUC29294W Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Nein Electrolux EUC29294W.
Wir stellen 1 PDF-Handbücher Electrolux EUC29294W zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung
Komentáře k této Příručce