EMC Qlogic QLA23xx Instalační příručka stáhnout pdf (Strana 107)

Special instructions for the EMC CLARiiON CX-200-series

107

Miscellaneous Planning and Procedures

Special instructions for the EMC CLARiiON CX-200-series

This section contains the following information:

◆ “Set the HBA FC-AL loop ID” on page 107

◆ “Direct-connect dual-host clustering configurations” on page 109

Set the HBA FC-AL loop ID

While configuring a QLA234x HBA for Windows 2000 and

connection to CLARiiON CX200-Series for direct-connect cluster

configurations, you must manually set the HBA FC-AL Loop ID.

Follow these steps to enable loop hard addressing and set the loop ID

on each HBA:

Perform this procedure on all nodes in the cluster connected to the

CX200-Series array.

1. Boot the Windows host; press Ctrl-Q when prompted to Press

<CTRL-Q> for Fast!UTIL. (This prompt appears with the QLogic

startup banner.)

2. After the Fast!UTIL program loads, the initial display depends on

whether there are multiple QLogic HBAs installed in the server:

• If there is only one QLogic HBA, the Fast!UTIL Options menu

appears.

• If there are multiple QLogic HBAs, a list of memory addresses

occupied by those HBAs appears.

Using the arrow keys, select the desired HBA and press

ENTER.

The Fast!UTIL Options menu appears.

3. Select Configuration Settings from the Fast!UTIL Options menu,

and press Enter.

4. Select Host Adapter Settings from the Configuration Settings

menu.

5. Select Adapter Hard Loop ID from the Host Adapter Settings

menu and press

ENTER until the value is Enabled.

6. Select Hard Loop ID and press Enter.

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 127 128

Žádné komentáře

EMC Qlogic QLA23xx Instalační příručka Strana 107