EMC Qlogic QLA23xx Instalační příručka stáhnout pdf (Strana 43)

Booting from the external storage array

Installation and Configuration

• The utility will install the EFI-compatible firmware onto the

HBA(s) installed in the server (as shown in Figure 24 on

page 42), and return to the EFI shell when complete.

• If any errors are reported during this process, verify that the

correct EFI-compatible firmware for your HBA has copied to

your installation media.

4. The appropriate NVRAM settings must now be loaded onto the

HBA(s). Type

efiutil all nr=nvram23.dat (nvram23.dat is

the default NVRAM data file for QLA23xx-based HBAs). Press

Enter.

Figure 25 Data loaded onto HBA(s) installed in server

• The NVRAM data will be loaded onto the HBA(s) installed in

the server (as shown in Figure 25), and return to the EFI shell

when complete.

• If any errors are reported during this process, verify that the

correct NVRAM data file (

nvram23.dat) for your HBA has

copied to your installation media.

5. Type reset at the EFI shell prompt to reboot the server, allowing

the updated drivers, firmware, and NVRAM settings to take

effect.

6. Following the reboot, type fsN: (where N is the number which

references the proper file system, as described earlier).

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 127 128

Žádné komentáře

EMC Qlogic QLA23xx Instalační příručka Strana 43